Need help?Do you have a question about the Axis M3068-P and is the answer not in the manual?
General| Model | Axis M3068-P |
|---|---|
| Type | Fixed dome |
| Environment | Indoor |
| Resolution | 1920 x 1080 |
| Day/Night Functionality | Yes |
| Compression | H.264, H.265, Motion JPEG |
| Ethernet | 10BASE-T/100BASE-TX |
| Power over Ethernet | IEEE 802.3af |
| Ingress Protection | IP42 |
| Vandal Resistance | IK08 |
| Image Sensor | Progressive scan RGB CMOS |
| Minimum Illumination | B/W: 0.04 lux |
| Audio Support | Yes, Two-way audio |
| Operating Temperature | 50 °C |
| Operating Conditions | 10-85% RH (non-condensing) |
| Protocols | IPv4, IPv6, HTTP, HTTPS, TCP, UDP, RTP, RTSP, FTP, SMTP, SNMP, DHCP, DNS, NTP, UPnP |
| Lens Type | Fixed |
Preview mode is ideal for installers when fine tuning the camera view during the installation.
Instructions on how to find and assign IP addresses for Axis devices on the network.
Steps to access the device's web interface by typing its IP address or hostname.
Recommendations for creating strong passwords and protecting device data.
Instructions for configuring image settings like rotation, quad view, and capture modes.
How to adjust exposure modes to optimize image quality for different lighting conditions.
Instructions on how to view and record video streams from the device.
Configuring network storage to save recordings from the device.
Configuring network settings, including IP address, hostname, and DNS.
Procedure to reset the device to factory defaults and troubleshoot firmware problems.
To Next Page
