36
AXIS P1311 - About
About
Here you can find basic information about your network camera. You can also view third party software licenses.
Resetting to Factory Default Settings
To reset the camera to the original factory default settings, go to the System Options > Maintenance web page (as described
in Maintenance, on page 34) or use the Control button on the side of the camera (see page 4) as described below:
Using the Control Button
To reset the camera to the factory default settings using the Control Button:
1. Disconnect power from the camera.
2.
Press and hold the Control button and reconnect power.
3. Keep the Control button pressed until the Status indicator color changes to amber (this may take up to 15 seconds).
4. Release the Control button.
5. When the Power indicator changes to green (which may take up to 1 minute), the process is complete and the camera
has been reset. The unit now has the default IP address 192.168.0.90
Note:
For other methods of setting the IP address, please refer to the product’s Installation Guide that accompanies the
product, or download a copy from www.axis.com
To Next Page
Loading...
Need help?
General
