AXIS P14 Series
How to repaint the product
4
2. Introduction
The following document is a guide to repaint AXIS P1445/47/48-LE Network Camera. The
document should be read in conjunction with the “Axis cameras and accessories Generic repainting
manual” (Document: 3486_Repaint_AXIS_Generic.pdf).
This document informs the reader how to dissemble the product (as far as possible) and the
sensitive areas that require attention.
Masking is a critical part of the process and should be completed professionally. Failure to mask
sensitive areas could cause problems with assembling and function of the equipment.
All screw holes need to be masked before painting. Any areas that is not painted from factory or
have a different surface treatment than the rest of the part (threads, ground and electrical contact
surfaces) must also be masked to ensure function.
Always employee a professional to undertake the painting work. It is advisable to complete a
single unit before painting a batch to ensure that the masking process is correct and that the finish
is satisfactory.
Axis’ Warranty will not automatically be deemed void due to the disassembly and reassembly of
Cameras; provided the following conditions are fulfilled (the list shall not be construed as an
exhaustive list):
• The purpose for disassembling and reassembling the Cameras is repaint work only;
• The disassembling and reassembling is carried out in a professional and careful manner and does
not intervene with normal operation of the Cameras.
Note that if the camera has a support problem and needs to be replaced, Axis will not repaint the
camera.
Please note in conjunction to the above and when repainting: The performance of the Cameras
may deteriorate due to the repainting according to the following (the list shall not be construed as
an exhaustive list):
o Paint will add weight to the Cameras and speed and acceleration may be affected;
o Darker colors will absorb more sunlight and the relevant temperature specification of the
Cameras may become limited;
o Increased friction in joints of the Cameras will increase strain and may affect the lifetime
expectancy;
o Any paint used must be compatible (non-damaging) to plastics and glass; o The Axis label with
the product part number and serial number must be clear and legible at all times;
o Repainting may only be done to the casing and/or stand of the Cameras, under no
circumstances may lenses be repainted;
To Next Page
Loading...
Need help?
General
Weight and Dimensions
