Care and Maintenance
4-11
Storage and Winter Lay-up
Due to the problems that can occur from improper winterization, we recommend that you
take your boat to a certified Axis dealership to perform this task. Without proper preparation,
storage for long periods of time may cause parts of the engine and transmission to rust due to
lack of lubrication. Also, if your boat will be stored in freezing conditions, water inside these
components to include cooling system, heater and shower could result in major damage to
your boat. Damage done due to improper winter storage will void your warranty. Here is our
list of suggestions to keep your boat in top condition.
Prior to boat being removed from water:
• Fill fuel and add 1 ounce of STA-BIL
®
fuel stabilizer for each 5 quarts of gasoline.
• Operate boat for at least 15 minutes in water or using a flush system to allow
treated fuel to flush engine.
• Add lightweight engine oil (SAE-10 or fogging oil) slowly to the engine while
engine is slightly above idle. Turn engine off. Consult your local dealer for correct
procedure.
To be completed when boat is put on trailer or resting cradle:
• Remove bilge T-handle and transom drain plug immediately after removing the
boat from the water and drain all ballast tanks.
• Clean and dry the boat interior and exterior thoroughly. Inspect boat hull for residue
and remove if present.
• Clean bilge area thoroughly and operate the bilge pump to remove any water from
bilge lines.
• Remove all seat cushions and open all storage areas. Store the seat cushions in a
cool dry place.
• Apply coat of wax to entire gelcoat surface of boat.
• Flush engine-cooling system with clean water. Do not exceed 1500 RPM while
flushing for 5-10 minutes.
• Turn fuel supply line to the OFF position (handle perpendicular to fuel line).
Perform annual scheduled maintenance. Refer to engine owner’s manual for
complete engine winterization procedures as well as scheduled maintenance.
Note: Damage done due to improper engine winter storage will void your warranty. It is
highly suggested that you allow a trained Axis technician to perform this service.
• After performing engine winterization, remove engine safety switch and spin
engine over a few seconds to remove excess water found in pump bodies.
• Remove the negative cable from battery. Charge battery to fuel charge and remove
from boat.
• Clean all traces of dirt, oil and grease from engine, transmission and bilge. Coat all
areas on transmission and engine where paint has been removed with touchup
paint.
• Use duct tape to seal the exhaust flaps closed to prevent dirt and rodents from
entering exhaust.
• Remove propeller assembly, and store in safe place.
• If your boat is equipped with an optional heater or hot-water shower, remove both
hoses and blow through hose to remove excess water.
• Cover the boat with cover, tarp or, if available, shrink-wrap tarp. Also, due to the
excess weight that can occur from rain and snow for boats that are stored outside, it
is suggested that you make a support of 2 inch PVC piping that can be mounted
under the covering material. The rounded PVC piping will ensure the cover does
not tear and will eliminate pooling water inside boat.
Chapter 4_15_Axis.qxp_ Chapter 4 doc.qxd 6/19/14 10:32 AM Page 11
To Next Page
Loading...
Need help?
General
