Axis Wake Research User Manual

Gauges & Controls
2-23
Tower
FatAX Tower (Standard)
This tower’s main hoop is made of oversized 3" tubing and
the bases are billet aluminum and through-bolted with
backing plates.
Properly stow the bimini top in its boot and remove all
boards from the board racks prior to towing/trailering your
boat. Damage to the bimini from towing while not stowed
is not covered under warranty. Damaged or excessive wear
to board racks caused by towing or trailering with boards
attached is not covered under warranty.
Due to vibration and rough water conditions it is possible for
bolts to loosen. Before each use, inspect all mounting bolts
(Tower, Wakeboard Racks, Lights, Speakers, etc.) to ensure
they are tight. See your local dealer for any questions and/or
assistance. Failure to do so can cause serious damage and/or
injury to the boat and/or passengers.
The tower is rated for a maximum of 130 lbs (58.9 kg) accessory weight and not more
than 600 lbs (272.1 kg) total rider weight. Exceeding these limits voids any structural
warranty pertaining to the tower. Approved activities for usage of the tower include
wakeboarding, wake skating, skiing or tubing.
Exceeding these recommended tower weights may cause
damage to the tower and structure of the boat. Damage to the
boat and/or tower due to overweighting will not be covered by
the Axis boat warranty.
Only factory pre-drilled holes should be used to install factory accessories on the tower.
The use of aftermarket accessories not supplied by Axis Wake Research may cause
damage not covered by the tower warranty. Drilling any additional holes in the tower will
void any structural warranty.
Towers are configured with shocks to help stabilize the tower when the tower knobs/bolts
are removed for lowering the tower.
Appropriate care must be taken to ensure the tower is not allowed to fall.
Towers are configured from the factory with shocks based on the factory-installed
components. If ANY additional components are mounted to the tower after the boat
leaves the factory, it is the dealer and the consumer’s obligation to validate that the
installed shocks and the tower are rated for these additional components.
!
WARNING
Figure 2-29. FatAX
Chapter 2_15_Axis.qxp_ Chapter 2 doc.qxd 6/19/14 10:28 AM Page 23

Axis Wake Research Specifications

General

Brand	Axis
Model	Wake Research
Category	Boat
Language	English