Navigation/Anchor Lights
In the ANC (anchor) position, this switch is used to activate the all-around light on the
tower. Keep the all-around light on after dusk whenever your boat is at anchor in the open
waterway. While underway, place the switch in the NAV position to also activate the red
and green navigation bow lights.
Interior/Dash Lights
This switch is used to activate the interior lights. The interior lights include lights in the
gunnels, storage compartments, dashboard and optional underwater transom lights and
underseat lighting, if equipped.
Blower
This switch activates the blower for the engine compartment. The primary function of the
blower is to eliminate any fumes in the motor compartment prior to starting the engine
and while operating below cruising speed.
Gasoline Vapors Can Explode. Before starting engine, operate
blower for 4 minutes and check engine compartment for
gasoline leaks or vapors. Run Blower below cruising speed.
Bilge Pump
The bilge pump switch is used to activate the bilge pump so that
any excess water in the bilge area may be drained out. The bilge
pump has a sensor in the bilge area and will turn on automatically
whenever 2 in. or more of water is detected.
The bilge pump is wired directly to the battery. This circuit can be
identified by an inline fuse from the battery labeled “Auto Bilge
Power.” If your boat takes on water for any reason, the auto bilge
pump will activate and continue to run until the water level drops
low enough to deactivate the pump. If water continues to enter the
boat, the pump will continue to run until the battery is drained.
Docking Lights
This switch is used to activate the docking lights. Only use
docking lights during slow speed docking maneuvers.
Ballast Switches
These switches are used to fill or drain the corresponding ballast tank. Press up to fill the
tank. Press down to drain the tank.
Accessory #1
This switch is used to supply power to the optional heater unit. (For information on the
use of the heater, please see Heater in the optional equipment section of this manual.)
Accessory #2
This switch is used to supply power to aftermarket accessories. Attaching an accessory to
this switch should only be done by a qualified technician.
To Next Page
Loading...
Need help?
General
