To Next PageTo Next Page
Need help?Do you have a question about the Axminster TS-200 and is the answer not in the manual?
General| Type | Table Saw |
|---|---|
| Blade Diameter | 200 mm |
| Rip Capacity | 200 mm |
| Voltage | 230 V |
| Blade Tilt | 0° - 45° |
Illustrates various safety symbols and their meanings for machine operation.
Provides suggestions for safe operation, maintenance, and work environment.
Details essential safety checks for mains-powered tools and power cables.
Strict prohibition on children being present in the machine's operating area.
Advice on safe practices before, during, and after machine operation.
Warning against using the machine near flammable liquids or volatile gases.
Instructions on keeping the machine clean and precautions for the saw blade.
Instructions on disconnecting the machine and safe workpiece handling.
Checks for foreign objects in material and guidance for assisted operation.
Steps for initial setup and constructing the machine's stand.
Procedure for attaching the saw guard steel mesh and mounting the saw bench.
Steps for assembling the sliding carriage table components and carriage arm.
Steps for assembling and setting the angle fence to 90°.
Setting the angle fence between 45° and 90° and repositioning it.
Procedure for assembling and installing the mitre fence.
Steps for attaching handles and installing the saw guard.
Initial steps for assembling the extension table support arms.
Finalizing the extension table assembly by levelling and securing.
Procedure for assembling and attaching the fence to the extension table support arm.
Checking fence parallelism and lubrication for smooth operation.
Connecting dust extraction hoses to the table saw and saw guard.
Diagram illustrating the main table saw and its key components with labels.
Procedure for correctly positioning the riving knife and ensuring fence parallelism.
Procedure for angling the saw blade up to 45° using the pivot locking handle.
Ensuring machine security, blade condition, and connecting to mains supply.
Guidance on feeding timber manually, using push sticks and safety precautions.
Using the fence for cutting narrow pieces of timber.
Mounting and angling the mitre fence for cuts.
Steps for safely removing and replacing the saw blade.
Procedures for keeping the saw clean, vacuuming, and removing resin build-up.
Inspecting drive shafts, belts, and saw blade condition.
Cleaning the bench after use and preparing for storage with oil and dust sheet.
Diagram showing numbered parts of the TS-200 table saw for identification.
Detailed list of parts for the TS-200 table saw with part numbers and quantities.
Diagram and list of parts specific to the sliding carriage assembly.
