AXON BODY 2
Quick Tip Guide
Turning ON Camera
1. Turn the system on. Move the ON/OFF switch to the ON position.
• The camera takes a few seconds to boot up and be ready to record (the red area under the
switch will be exposed with the switch moved to the ON position).
• The operation LED will be solid red and then transition to blinking green when the system
goes into BUFFERING mode.
• The Axon Body 2 camera will go into BUFFERING mode after the boot up sequence.
Buffering is set to capture activities that occur 30 seconds before you activate the EVENT
(recording) mode.
To Next Page
