Axon Body 2 Quick Tips Guide

2. Open the Axon View.
3. Tap (Settings icon) in the upper-left side of the screen to go to the Settings.
4. Under the Camera section, tap the switch to the right of the Stealth Mode to change the setting.
If the switch is toggled to the right, stealth mode on the camera is enabled: the camera will not
beep or vibrate, regardless of other settings, and all camera lights are off. If the switch is toggled
to the left, stealth mode on the camera is disabled: the camera beeps and vibrates. Camera lights
operate normally.
Audio prompt and vibration guide
The Axon Body 2 camera emits beeping sounds called “audio prompts” to notify you of the system status.
These audio prompts usually occur after you perform an action with the body camera. For some actions, the
camera also vibrates while making an audio prompt.
OPERATING MODE
AUDIO
NOTIFICATION
VIBRATION
Powering on or off
One beep
Once
Recording an event
Two beeps (every two
minutes)
Twice (every two
minutes)
Press the battery button while the camera is recording
Two beeps
None
The device is ending an event and returning to
BUFFERING mode
One long beep Once, long-duration
Low battery notifications:
Camera in BUFFERING mode and battery has power for
20 minutes or less (the camera will not record)
Camera in EVENT (recording) mode and battery nearly
discharged (the camera will shut down within a few
minutes)
Four quick beeps (every
20 seconds)
Four times, quickly
(every 20 seconds)
The camera memory is full. The camera will not start
recording.
Three beeps Three times
The camera internal clock is not set. Place in an Axon
Dock or connect to Evidence Sync to correct this issue.
Five beeps (every 20
seconds)
Five times (every 20
seconds

Axon Body 2 Specifications

General

Frame Rate	30 fps
Storage	64 GB
Pre-Event Buffer	Up to 2 minutes
Water Resistance	IP67
Operating Temperature	-4°F to 122°F (-20°C to 50°C)
Field of View	143 degrees
Battery Life	12 hours
Video Resolution	1080p
Weight	148 g (5.2 oz)