Axon Fleet 2 Installation Manual

Axon Fleet 2 Installation Manual
Axon Enterprise, Inc. Page 32 of 39
Axon Signal Vehicle Wiring Instructions
Position Description
J2-1 +12VDC (Fuse @ 1A)
J2-2 Ground
J2-3 Ignition Enable
J2-4 Auxiliary Enable
J2-5 thru J2-10 Trigger Input
J2-11 and J2-12 Trigger Input – Delayed Turn Off
System Power (positions 1 and 2)
Note: Power ground and Ignition are found from the power unit to vehicle cable (SKU
71100)
Optional Auxiliary Enable (position 4)
The J2-4 input is used to provide an alternate signal to Axon Signal Vehicle for enabling the
system.
Note: Either the Ignition Enable or Auxiliary Enable input on Axon Signal Vehicle must be
used for the device to turn on. Both inputs may be used simultaneously to allow for greater
flexibility in enabling options, but at least one must be utilized. Axon Signal Vehicle must be
wired in a manner such that voltage for Ignition and Auxiliary Enable is removed prior to
removal of system power (system power and enable nodes must not be wired from the
same source).
Trigger Input (positions 5 through 12)
1. Turn on the trigger source (e.g. light bar control signal).
9 11 1 2 3 5 4 6 7 8 10 12
J2
Power
Ground Ignition Enable
Aux Enable
Trigger Inputs

Axon Fleet 2 Specifications

General

Brand	Axon
Model	Fleet 2
Category	Car Video System
Language	English