3 Once each camera is in BUFFERING mode, test the Axon Signal Vehicle unit, to
ensure the desired triggers properly activate the system.
For more information, see the Axon Signal Vehicle Unit Installation Manual.
• If there are any errors, go to Chapter 3: Troubleshooting.
• If no errors are noted, continue to Step 7: Completion.
Step 7: Completion
1 Ensure all wiring is appropriately dressed and tucked away.
Use extreme caution to not to expose wiring to any place where it would likely
be damaged. Keep in mind, if vehicle trim was removed, special care will be
necessary to replace trim without damaging the Axon Fleet system.
2 Replace vehicle trim and body pieces as necessary.
3 Repeat testing procedures to ensure the system is fully functional.
To Next Page
Loading...
Need help?
General
