Installation
Warnings
Failure to follow the instructions in this manual may result in Axon Signal Vehicle not working
properly or cause damage to the device or the vehicle. Save these instructions.
The technician who installs Axon Signal Vehicle must be qualified to work with automotive
electronics.
If mounting Axon Signal Vehicle requires drilling holes, ensure drilling will not damage the
emergency vehicle’s equipment or other vital parts. Remove all burrs and debris after
drilling. Install grommets into all wire passage holes.
Ensure there is a good electrical ground to the vehicle chassis.
If Axon Signal Vehicle is installed in the cab of the vehicle (in a location other than under the
center console), it should be permanently mounted to avoid injury.
Do not install Axon Signal Vehicle anywhere that will interfere with airbag deployment.
Do not install Axon Signal Vehicle where it will be exposed to the elements or extreme heat.
Do not install Axon Signal Vehicle in the vehicle’s engine compartment.
Guidelines
Axon Signal Vehicle is typically installed near the siren or light bar controller (trunk or
console).
Axon Signal Vehicle can be installed using robust double-sided tape, VELCRO® type hook
and loop fastener, or by bolting the device through its mounting flanges (mounting hardware
and electrical supply wiring not included). If using an adhesive to mount the equipment,
thoroughly clean the surface with a 50/50 mixture of isopropyl alcohol and water before
installation.
Axon recommends using gauge 18 AWG wires.
All wires should be connected to the GPIO terminal block interface.
Axon recommends installing a 1-amp fuse, either inline or on a fuse block, for the J2-1
position.
No programming of Axon Signal Vehicle is required for operation. However, have the input
settings reviewed by an Evidence.com administrator. See the Evidence.com User and
Administrator Guide for information on signal configuration.
Signal Vehicle User and Installation Guide
Axon Enterprise, Inc. 4
To Next Page
Loading...