Axxera AXD530 - Preparation and Installation; Before You Start Installation; Getting Started with Installation

2
AXD530
Please read entire manual before installation.
Before You Start
•Disconnectnegativebatteryterminal.Consultaqualifiedtechnicianforinstructions.
•Avoidinstallingtheunitwhereitwouldbesubjecttohightemperatures,suchasfrom
directsunlight,orwhereitwouldbesubjecttodust,dirtorexcessivevibration.
Getting Started
•Removetrimringfromunit.
•Remove2transitscrewslocatedontopoftheunit.
•Insertthesuppliedkeysintotheslotsasshown,andslidetheunitoutofthemounting
sleeve.
•Installmountingsleeveintoopening,bendingtabstosecure.
•Connectwiringharnessandantenna.Consultaqualifiedtechnicianifyouareunsure.
•Certainvehiclesmayrequireaninstallationkitand/orwiringharnessadapter(sold
separately).
•Testforcorrectoperationandslideintomountingsleevetosecure.
•Snaptrimringintoplace.
Preparation
REMOVAL
KEYS
HEAD UNIT
MOUNTING SLEEVE
OPTIONAL REAR
MOUNTING SUPPORT
TYPICAL DIN FRONT-LOAD MOUNTING METHOD