After entering the setup mode, the front panel will display “Set1
[current name]
”, where “current name” indicates the name currently
selected for input 1. (The factory default setting is “
Unused”,
which de-activates input 1.)
Use the left-hand knob to select which input (
1 - 8) you wish to
configure. Then press the right-hand button to enter the next
menu level. The left-hand knob will select which setting you
wish to configure for that input.
18
Name
Offset
Balance
Gain
AyreLink
Set1 [current name]
To Next Page
Loading...
