Need help?Do you have a question about the Azden i-coustics pro-xd and is the answer not in the manual?
FCC statement on interference and compliance for Class B digital devices.
Statement on FCC RF and IC RSS-102 radiation exposure limits and installation.
Guide to setting microphone gain and receiver output for best audio quality.
Instructions for connecting the PRO-XD system to smartphones and tablets.
Operating Specifications| operating frequency | 2.4GHz ISM Band |
|---|---|
| dynamic range | 90dB |
| signal-to-noise ratio | 80dB |
Range and Response| operating range | 35m typical; up to 120m in ideal conditions |
|---|---|
| frequency response | 20Hz - 20kHz, ± 1dB |
| digital sampling | 48kHz/16bit |
Battery and Power| system latency | 14ms |
|---|---|
| battery life span | 300 cycles |
| power supply | USB 5V |
Output Specifications| RF output power | 10mW |
|---|---|
| max output level | -14dBV |
| mic output | Φ3.5mm dual-mono/stereo |
Battery| battery life | 16 hours |
|---|---|
| battery charge time | 3 hours |
| output impedance | Mic: 600Ω; Headphone: 16Ω |
Physical Characteristics| headphone output | Φ3.5mm stereo |
|---|---|
| dimensions | 48x79x14mm (W/H/D) |
| weight | 68g |
Input Specifications| RF output power | 10mW |
|---|---|
| mic input | Φ3.5mm mono TRRS |
| aux input | Φ3.5mm stereo, line level |
Battery| battery life | 11 hours |
|---|---|
| battery charge time | 3 hours 30 min |
| max input | 300mV RMS |
Physical Characteristics| dimensions | 48x79x14mm (W/H/D) |
|---|---|
| weight | 62g |
| input impedance | Mic: 2.2kΩ; Aux: 10kΩ |
Microphone Specifications| mic element | Electret Condenser |
|---|---|
| polar pattern | Omni-Directional |
| frequency response | 30Hz - 20kHz |
Electrical Characteristics| sensitivity | -46dB at 1kHz (0dB=1V/Pa) |
|---|---|
| impedance | 2.2kΩ (at 1kHz) |
| power requirement | Plug-in power DC 1-10V |
Physical Characteristics| connector type | Φ3.5mm TRRS |
|---|---|
| cord length | 105cm |
To Next Page
