EN-25 EN-26
Custom-designed JYX05 Type-C 3-Lead Hardwire Kit is required
to use this new feature. Not included in the packaging,
on Amazon search: JYX05 Type-C 3-Lead Hardwire Kit for
M330 Dash Cam
Note:
Parking Mode
This function will ONLY work when 3-Lead Hardwire Kit is installed
properly. This parking mode has three options to choose from.
Time-Lapse Parking Mode:
*
1. When you turn OFF the car's engine and turn the key to the lock
position. Then the camera will STOP the continuous video recording
and it will go into the timelapse 1fps recording mode automatically.
2. Now while this timelapse is being recorded, if someone hits your
car and if the impact reaches the set G-Sensor level, then the
camera will start to record 1-min continuous video, save & lock that
video in Event folder > then return to the timelapse 1fps recording.
3. Now when you start your car for the next time, the camera will
automatically STOP the timelapse parking mode. Then it will go
into normal video mode automatically to start the continuous video
recording.
or gravitational impact force on the camera, the current
video file will be locked as an emergency file so it won't be
deleted by loop cycle function. The higher the G-Sensor
sensitivity is, the less force will be needed to trigger
automatic file protection.
Fatigue Driving Reminder— Off(Default)/ 2H
When you activate this feature, the dash cam will beep every
2 hours to remind you if you are experiencing fatigue while
driving.
Collision Detection Parking Mode:
*
1. When you turn OFF the car's engine and turn the key to the lock
position. Then the camera will STOP the continuous video recording
and it will go into the impact detection mode and the camera will
turn OFF.
2. Now while the camera stays in impact detection mode, if
someone hits your car and if the impact reaches the set G-Sensor
level, then the camera will turne ON > then it will start to record
1-min continuous video, save & lock that video in Event folder >
then the camera will turn OFF.
3. Now when you start your car for the next time, the camera will
automatically go back into normal video mode automatically to
start the continuous video recording.
Normal Recording Parking Mode:
*
1. When you turn OFF the car’s engine and turn the key to the lock
position. The camera will continue to record normally.
2. Now the camera stays in impact detection mode, if someone
hits your car and if the impact reaches the set G-Sensor level, then
the camera will lock the current looping video clip, save & lock that
video in Event folder > then the camera will continue to record
normally.
To Next Page
Loading...
