EN-35 EN-36
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
This equipment complies with FCC radiation exposure limits
set forth for an uncontrolled environment. This equipment
should be installed and operated with a minimum distance of
20cm between the radiator & your body. This transmitter
must not be co-located or operating in conjunction with any
other antenna or transmitter.
This product complies with the radio interface
requireme-nts of the European Community.
This symbol means the product must not be discarded as
household waste, and should be delivered to an appropriate
and recycling helps protect natural resources, human health
and the environment. For more information on disposal and
recycling of this product, contact your local municipality,
disposal service, or the shop where you bought this product.
Changes or modifications not expressly approved by the
party responsible for compliance could void the user's
authority to operate the equipment.
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation.
14. Notice
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for
help.
Q7: Voice prompt Memory Error?
Using unqualified SD or third party cards can affect dashcam's
performance and in some cases, force the dashcam to reboot
randomly during recording. If it still can not work normally, it
should be that the TF card is unqualified and can not meet the
recording requirements of the dash cam. Please contact us to
get a new memory card.
To Previous Page
Loading...
