User Manual
Page 16 of 40
Step 2
Press the Simple Connect button for 2 seconds on HomePlug Y. After you release the
button, the Power LED will blink. If the Power LED did not blink, press Simple
Connect again for two seconds.
Step 3
Press Simple Connect for two seconds on HomePlug X. After you release the button,
the Power LED will blink. If the Power LED did not blink, press Simple Connect
again for two seconds.
Pairing between two devices are only given two minutes upon pressing the Simple
Connect button for two seconds on HomePlug Y. After pressing Simple Connect on
HomePlug Y, make sure to press Simple Connect on HomePlug X within two minutes
to ensure a successful connection, otherwise repeat steps 2 and 3 until the LEDs of
both devices switch OFF and on twice, indicating that they are paired with one
another.
To Next Page
Loading...
