Easy Start
Easy Start Page 4 of 20
Important Safety Instructions
Please read these instructions carefully:
1. Unplug the HomePlug Ethernet Adaptor from the wall outlet before cleaning. Do not use
liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning.
2. Do not use the HomePlug Ethernet Adaptor near water.
3. The HomePlug Ethernet Adaptor should never be placed near or over a radiator or heat
register, or in a built-in installation unless proper ventilation provided.
4. The HomePlug Ethernet Adaptor should be operated from the type of power indicated on
the marking label. If you are not sure of the type of power available, consult your dealer
or local power company.
5. The HomePlug Ethernet Adaptor relies on the building’s electrical installation for short-
circuit (over current) protection. Ensure that a fuse or circuit breaker no larger than 120
VAC or 230 VAC (depends on the power supply type in your country) is used on the
phase conductors (all current-carrying conductors).
6. Plug the HomePlug Ethernet Adaptor directly into a 120V AC or 230V AC (depends on
the power supply type in your country) wall outlet. Do not use an extension cord between
the adapter and the AC power source.
7. Do not attempt to service the HomePlug Ethernet Adaptor yourself, as opening or
removing covers may expose you to dangerous voltage points or other risks as well as
ruin the product warranty. Refer all servicing to qualified service personnel only.
8. Unplug the HomePlug Ethernet Adaptor from the wall outlet and refer the product to
qualified service personnel for the following conditions:
• If liquid has been spilled into the product.
• If the product has been exposed to rain or water.
• If the product does not operate normally when the operating instructions are
followed.
• If the product exhibits a distinct change in performance.
To Next Page
Loading...
Need help?
General
