Easy Start
Note…
1. Before connecting the HomePlug Ethernet Adaptor, please note its Security
ID / Device Password and keep it available for configuration of the network.
2. No drivers are required for installation of the HomePlug Ethernet Adaptor.
Note…
If there is no connection/link among the HomePlugs with the Network cable
inserted onto the HomePlugs OR the ping test among the HomePlugs are not
successful, please power off and on again for the HomePlugs.
You can also plug out the HomePlugs and then plug in again with the present of
the Network cable.
Uninstallation:
1. To uninstall the Configuration Utility, go to the Control Panel of your system.
2. Open the Add/Remove Programs.
3. Select and double click on the PowerPacket Ethernet Adapter in the Add/Remove
Programs Properties.
4. Follow the on screen instructions to uninstall the PowerPacket Utility.
Easy Start Page 7 of 20
To Next Page
Loading...
