12
Setting up your WMB250AC as Mesh Node
WMB250AC is a Mesh-Ready device as a Mesh Node. Before you set up your mesh
system, you will need two units of WMB250AC. One unit will be connected to the
main router and will be known as the main AP/Controller unit. The second
WMB250AC will be the Mesh Node unit.
To set up your Mesh System with WMB250AC;
1. Ensure that there is already a WMB250AC connected to the main
router as an AP.
2. Connect the second WMB250AC mesh node to your laptop via LAN
cable and access 192.168.1.100 using your internet browser.
3. Set the Wi-Fi Password of the WMB250AC mesh node to the same Wi-Fi
SSID (Network name) and Password as your WMB250AC main AP.
4. Reboot your WMB250AC node.
5. Wait for the Mesh LED of the main AP and mesh node to turn solid
WHITE.
6. When the Mesh LED on both the main AP and mesh node is solid
WHITE, pairing and link is successful and up.
7. The whole pairing process takes up to 3 minutes.
8. You may now move your mesh node.
To Next Page
Loading...
Need help?
General