• Get a cup or bottle larger than 300ml and place it under the Funnel.
• Press the “ml” button on the Control Panel repeatedly until the LCD screen says “300ml”.
• Now press the “Start” button on the Control Panel. The Formula Pro® Advanced will dispense 300ml of water.
• Dispose of the water dispensed, or use it to water your plants.
Before you start preparing bottles for your baby
Attention: Don’t take anything apart yet. Follow these steps
before doing anything else.
Now let’s rinse the inside of the machine.
B) Clean the removable parts
A) Rinse the machine
Unplug the machine, remove all the parts shown on the next page.
Formula Pro®Mini - parts
• Thoroughly clean any surface that is likely to come into contact with the Formula Pro® Mini or any of the components.
• Place the Formula Pro® Mini on the counter or other level surface and turn it around so the back is facing you.
• Remove the Water Tank and Water Tank Lid from the back of the machine, wash it with hot soapy water and rinse
thoroughly, then air dry.
• Fill Water Tank with bottled water suitable for infant formula preparation, or pre-boiled water, cooled to room
temperature (45°C or below).
• Place Water Tank and Lid back on Base, turn the machine around so the front is facing you and then plug it in. The
machine will turn on and the LCD screen will light up.
• The machine will beep once to tell you it’s powered on. You’ll also see the LCD display turn on. If the LCD screen is not lit
up when plugged in, press the power button to turn on the machine.
• Remove all the parts from the machine as shown on page 4.
• Wash all the parts except for the machine itself in hot soapy water and allow to thoroughly air dry.
• NEVER wash any of the parts in a dishwasher, steriliser or microwave.
• Get familiar with the part names on the next page before moving to section C.
Powder Container Lid
Stirring Wheel
Locking Cover with Silicone Scraper
Measuring Wheel
Powder Container
Axle
Powder-Dispensing Hole
Control Panel
Base
Power Cord
(on back - not shown)
Drip Tray
Funnel
Water Tank
Water Tank Lid
Funnel Cover
Funnel Compartment
Disassemble and wash all parts (except the Base) and
allow to air dry. Assemble as shown on pages 5 & 6.
Never clean any of the parts in a
dishwasher, steriliser or microwave!
For use with tall bottles typically
240ml or larger, a riser base
is available for purchase
separately at babybrezza.co.uk
43
To Next Page
Loading...
