1
2
4
3
C) Assemble your Formula Pro®Mini
Now place the Powder Container on the Base
with the printed markings facing you.
Now place the Stirring Wheel on the Axle
and push down rmly until you hear a 'click'.
When the Stirring Wheel is properly 'clicked'
into place it will not lift up easily.
Place the Axle on the Base as shown.
Wash these parts in hot soapy water and
completely air dry before assembly.
Assemble the Funnel and Funnel Cover.
Then insert funnel assembly into Funnel
compartment by sliding it up, then in.
Make sure the Locking Cover is snapped onto
the Measuring Wheel and looks like this
when assembled.
Place the Measuring Wheel into the Powder
Container, tting it over the Axle with the at
side facing down.
Make sure the holes in the Measuring Wheel
are in the same position as shown above.
1. Place the front edge of the Locking Cover
in the recess in the inside/front of the
Powder Container, under the tab.
2. Fit hole in Locking Cover over the Axle and press
down to lock in place.
Set-up and cleaning videos available at
www.babybrezza.co.uk
6
1
2
5
IMPORTANT
87
click
click
click
click
65
To Next Page
Loading...
