1 2
Monthly Cleaning
Instructions
Hand wash all parts shown above with warm
soapy water, rinse well and air dry thoroughly.
Hand wash Water Tank and Lid with warm soapy
water, rinse well and air dry thoroughly.
Easy Daily Cleaning Instructions
Once a month, give your Formula Pro® Mini a thorough cleaning.
Monthly Descaling Instructions
It is necessary to remove all formula from the Powder Container for the monthly descaling.
To prevent mineral scale on the water heater inside your Formula Pro® Mini, follow these easy steps:
1. Remove the Water Tank, empty it and ll it with 400ml of puried water and 400ml distilled vinegar.
2. Place the Water Tank on the Base of the machine and place a cup larger than 300ml under the funnel.
3. Select “300ml” with the “ml” button, then press the “Start” button to dispense.
4. Empty the cup, place back under the Funnel, then press the “Start” button again to dispense another 300ml.
5. Now unplug the machine, remove the Water Tank, and empty it. Let the machine sit for 4 hours.
6. Wash, rinse and ll the Water Tank to the “MAX” line with sterile or pre-boiled cooled water, then place it
back on the Base.
7. Plug in the machine, place a cup to catch 300ml water and use the “Start” button to run an 300ml cycle.
Dispose of the water dispensed in the cup and then repeat this step to run the entire tank of water through the
machine. When the “Low Water” indicator turns on, you’re done rinsing.
8. Rell the Water Tank with sterile or pre-boiled cooled water and return to normal use.
It is EXTREMELY IMPORTANT to clean the funnel after every 4 bottles made.
This will keep your Formula Pro® Advanced dispensing accurately.
The machine will not work unless the Funnel is cleaned after every 4 bottles.
Always make sure Funnel & Funnel Cover are COMPLETELY DRY before re-assembling.
Always thoroughly wash your hands and any surfaces that will be used before the daily or monthly clean.
2
3
1
Remove Funnel & Funnel Cover by pulling
out and down.
Wash Funnel & Funnel Cover with warm,
soapy water & rinse well.
Air dry completely before re-installing.
Wipe the Powder-Dispensing Hole on the
underside of the Powder Container using a
dry paper towel or soft dry cloth.
IMPORTANT
PLEASE NOTE: You don’t need to remove the Powder Container or the Powder Container parts for daily cleaning.
To make daily cleaning even easier, you can
purchase an spare Funnel & Funnel Cover on
Babybrezza.co.uk. Then you can swap the
spare Funnel with the Funnel that needs to be
cleaned. NOTE: you will still need to wipe the
Powder-Dispensing Hole as shown in Step 3.
Suggestion to make cleaning easier
Set-up and cleaning videos available at
www.babybrezza.co.uk
1211
To Next Page
Loading...
