Feed Dog Position
Standard：
Left /Right: Feed dog comes to the center, means a=b (#1).
Front /Rear: The clearance between feed dog and needle plate
is 3.2 to 3.8mm (#2)
1. Go to the test mode #06, then press .
2. Remove the needle plate A.
3. Loosen the 2 screws (#3), then adjust feed dog
position. (Temporarily attach the needle plate A.)
4. Tighten the 2 screws (#3).
5. Attach the needle plate A.
#1
#3
#3
Only loosen to
adjust F/B position
See next page for
L/R position
#2
To Next Page
Loading...
