One Point Adjustment
Standard： The shape of sewn pattern should be meets the standard.
1. Go to the test mode #03, and attach the “N” presser foot.
2. Use the Shappe spun #60 thread, and sew the test pattern.
3. Press to adjust the shape of sewn pattern as below.
OK
NG#1
Lap : Push vertical
Open : Push vertical
NG#1NG#1NG#2
NG#3
NG#4
Not align
If lower part short : Push horizon
Not align : Push horizon
If lower part long : Push horizon
To Next Page
Loading...
