Standard： In the test mode #39, Total length of forward feed is more
than 140mm. And the difference between the length of
forward and backward feed is within 5 mm.
1. Attach the dual feed foot and go to the test mode #39.
2. Detach the foot part (#1) of dual feed foot, then put a paper.
3. Press the Start/Stop button. Sewing starts.
4. Check the total length of each feed.
5. Press to adjust the feed length.
6. Press ”CLOSE”.
more than
140mm
more than
140mm
OK
OK
#1
Dual Feed
To Next Page
Loading...
