Baby Lock Evolution BLE8W-2 - How To Use The Needle Threader; Front Cover Seam Guide

Use the marks on your serger's front cover to align the fabric the desired seam width.
Set the width dial at the "M" setting for accurate seam allowances.
T
H
R
E
A
D
I
N
G
24
How To Use The Needle Threader
5/8 inch
5/8 inch
A
B
1. Hold the needle threader with the arrow mark on top.
Place the thread in the groove of the needle thread-
er. (fig.A)
2. Push the needle threader against needle and slide
down the groove of the needle to the eye. Push the
thread into the eye of the needle.
3. With a point of the needle threader or the tweezers
pull the loop of thread from the back of the needle,
under the foot and to the back left.
Front Cover Seam Guide
1. The chain stitch (C-3) combined with the 3 thread
overlock is the most common 5-thread combination.
The mark closest to the needles indicates 5/8 inch
(16mm) from the cutting edge to the C-3 chain needle.
2. When using the left overlock needles (O-1) for either
a 3 or 4 thread overlock seam, the second mark from
the needles indicates 5/8 inch (16mm) from the cutting
edge to the O-1 overlock needle.
3. Use the right overlock needle (O-2) for 3 thread over-
lock seam and the third mark from the needles indi-
cates 5/8 inch (16mm) from the cutting edge to the O-
2 overlock needle.
4. Other marks on the front cover are for any custom
seam allowance.
Note: Be sure to set the width dial at the "M" setting for accurate seam allowances.