Bacharach INJECTOR CALIBRATOR CD3 - Page 10

Page 1-4 Bacharach, Inc. Instructions 67-9319
INTRODUCTION INJECTOR CALIBRATOR CD3
" A "
B O D Y T O S E A T C L A M P
" B "
P l u n g e r t o B o d y C L A M P
Feature Operation
___________________________________________________________________
“A” OR “B” Button There is no physical movement of the clamping mechanism
when this button is pressed but it must be held down to
operate the body to seat clamp or plunger to body clamp.
This is part of the two hand safety operation system.
_____________________________________________________________________
Figure 1-4. Right Table Features
RIGHT OPERATOR’S TABLE FEATURES
Feature Operation
___________________________________________________________________
“A” Clamps body to seat. Will operate only when flywheel
BODY TO SEAT is in a certain angular position and the HOLD TO
CLAMP Button OPERATE “A” or “B” button is held down.
“B” Clamps plunger to injector body. Will operate only
Clamp/Unclamp lever when the HOLD TO OPERATE “A” or “B” button is
(4-way selector valve) held down.