Swing Beam Attachment
Phase 19
Phase Notes
• Assemble with hardware as shown.
Parts needed:
• (1) SWING BEAM ASSEMBLY
• (1) HC - BACKYARD DISCOVERY ID TAG - A100164
Hardware needed:
• (4) BG - T-NUT 5/16 - H100074
• (4) BX - WASHER SPLIT 5/16 - H100095
• (4) CD - WASHER FLAT 8x27 - H100105
• (4) AJ - BOLT HEX 5/16x1-1/4 - H100042
• (4) CY - SCREW PFH 8x5/8 - H100128
Step 1: Attach the Swing Beam Assembly to 'G2' Swing
Beam Support using Bolts 'AJ', Washer 'BX' & Washer 'CD'
through the 'GD' angle brackets & 'G2' swing beam support
and into T-Nuts 'BG' that will need to be hammered in the
holes on the backside of 'G2', as shown.
Step 2: Attach Backyard Discovery ID
Tag 'HC' on Swing Beam 'SB74' using
Screws 'CY', as shown.
SB74
HC
CY
AJ
BX
CD
G2
GD
BG
To Next Page
Loading...
