B
18
OPERATING PROCEDURES
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
Owner’s Manual
Looping the DC cord through the steering wheel when charging serves as a good reminder to store the cord out of the
way when finished with charging. The DC plug can be damaged by driving over or catching the cord on the vehicle
when driving away.
To reduce the possibility of a physical hazard that could result in an electrical shock or electrocu-
tion, be sure that the charger plug is not damaged and is inserted into a grounded receptacle.
An ungrounded electrical device may become a physical hazard that could result in an electrical
shock or electrocution.
Using the Charger
Before use, read the charger manufacturer’s operation manual that is supplied with the charger.
To prevent a physical hazard that could result in an electrical shock or electrocution, be sure that
the charger plug is not damaged and is inserted into a grounded receptacle.
An ungrounded electrical device may become a physical hazard that could result in an electrical
shock or electrocution.
The charger (DC) cord is equipped with a polarized connector that fits
into a matching receptacle on the vehicle. The receptacle is located in
the seat panel below the seat on the driver side of the vehicle.
Always check to be sure the receptacle is free from dirt and debris
before inserting the charger cord.
To Next Page
Loading...
Need help?
General
