30
MAINTENANCE
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
Owner’s Manual
LIFTING THE VEHICLE
Tool List Qty
Floor Jack.................................................................... 1
Jack Stands................................................................. 4
Wheel Chocks .............................................................4
To reduce the possibility of severe injury or death
from a vehicle falling from a jack:
Always place chocks in front and behind the
wheels not being raised.
Be sure the vehicle is on a firm and level surface.
Never get under a vehicle while it is supported by
a jack.
Use jack stands and test the stability of the vehi-
cle on the stands.
Use extreme care since the vehicle is very unsta-
ble during the lifting process.
When lifting the vehicle, position the jacks and jack
stands at the areas indicated.
Remove payload from vehicle before lifting. No person(s)
should be in or
on the vehicle while lifting.
Lift Entire Vehicle
1. Place wheel chocks in front and behind each front wheel.
2. Center jack under rear axle tube next to dif
ferential housing or under the skid plate.
3. Raise vehicle and position jack stands under the frame where the leaf spring mounting bracket
is w
elded to the frame.
4. Lower the jack and test the stability
of the vehicle on the two jack stands.
5. Place the jack under the center front of the car just behind the bumper.
6. Raise the vehicle and position the jack stands und
er the frame where the instrument panel
support is attached to the frame.
7. Lower the jack and test the stability
of the vehicle on all four jack stands.
Lift Front of Vehicle
1. Place wheel chocks in front and behind rear wheels.
2. Place the jack under the center front of the car just behind the bumper.
To Next Page
Loading...
Need help?
General
