Bad Boy RENEGADE Series User Manual

PAGE 10
SECTION 4: MOWER MAINTENANCE
Maintenance
Interval
Daily
First 8
Hours
Every 50
Hours or
Annually*
Every 100
Hours or
Annually*
Every
250
Hours
Section
Check and add engine oil

Section3
Check all belts for proper alignment

Section 2 (Pump)
6 (Deck)
Check tire pressure and wheel lug nuts

Section 5
Check battery terminal connections

Section 4
Check condition of blades

Section 6
Check for fuel and oil leakage

Section 3
Check deck and engine compartment for
debris and clean as necessary

Check air filters

Initial oil change

Section 3
Tighten nuts and screws

Change engine oil and filter

Section 3
Initial change of hydraulic oil and filter

Section 1
Grease mower

Section 5
Replace air element and pre-cleaner


Section3
Replace fuel filter


Section 3
Clean or replace spark plugs and set gap

Section 3
Change hydraulic oil and filter

Section 1
Clean combustion chamber
Dealer

Check and adjust valve clearance
Dealer

Clean and lap valve seating surface
Dealer

*Maintenance by hour or annually whichever comes first

Check air and fuel filter more often in dusty conditions
Dealer
Get maintenance performed at a registered dealership
SECTION 5: MOWER STORAGE &
TRANSPORTATION
5.1 Keep machine from collecting debris by storing in a covered area while not in use.
5.2 Disconnect the negative battery cable when machine will be stored for more than 30 days.
5.3 Always secure machine properly when transporting machine.
5.4 Do not load machine on trailer with blades engaged.
5.5 Do not use ramps to load the machine.
5.6 Make sure Parking Brake is in “up” position.
5.7 In wet conditions tires may spin while loading / unloading. If necessary, wait for dry conditions before
loading/unloading.
5.8 Make sure mode of transportation is suitable to bear the weight of mower.
5.9 Deck height should be set at maximum before attempting to load.
5.10 Secure mower with at least two straps capable of securing weight of mower.
5.11 Always ensure mower engine and exhaust has cooled prior to parking inside building.

Bad Boy RENEGADE Series Specifications

General

Spindle Material	Cast Iron
Horsepower	37 HP
Cutting Width	72 inches
Transmission	Hydro-Gear ZT-4400
Cutting Height	1.5 - 5 inches