PA
GE 15
SECTION 10: MOWER BLADE MAINTENANCE
10.1 Check mower blades after each use. This is essential for maintaining well-groomed turf. Keep the
blades sharp. If a dull blade is used for cutting, the grass will tear rather than cut. This could damage
the grass leaving a brown frayed top on the grass within a few hours. A dull blade will also require more
power from the engine.
10.2 NEVER attempt to straighten a bent blade by heating. NEVER attempt to weld a cracked
blade. The blades can break and cause serious injury or death.
10.3 NEVER work with blades while engine is running or deck clutch is engaged.
10.4 ALWAYS place deck clutch in DISENGAGE position while performing maintenance.
10.5 Use blocks when you MUST work under mower.
10.6 ALWAYS wear thick gloves when handling blades.
10.7 ALWAYS check for blade damage if mower strikes rock, branch, or other objects that could potentially
damage the blade.
(REMEMBER: NEVER CHECK BLADE WHILE ENGINE IS ON!
NEVER CHECK BLADES WHILE BLADES ARE ENGAGED!)
SECTION 11: EQUIPMENT LUBRICATION
11.1 Park the machine on a level surface and disengage the blade control switch.
11.2 Move the motion control levers outward to the neutral position, engage parking brake, stop the engine,
remove the key, and wait for all moving parts to stop before leaving the operating position.
11.3 Grease Type: NLGI grade #2 multi-purpose gun grease.
11.4 Clean the grease fittings with a cloth. Scrape any paint off the front of the fitting(s).
11.5 Connect a grease gun to each fitting. Pump grease into the fitting until grease seepage is observed. Be
mindful of over-pressurization. Do not force the lever arm if there is strong back pressure as this can
lead to reduced life of the component(s). Wipe up excess grease.
11.6 Refer to service manual section for grease fitting locations.
To Next Page
Loading...
Need help?
General
