Removing Software in Kiosk Mode
OTE:N This procedure is only for handhelds in Kiosk mode.
When operating the handheld in Kiosk mode, the main screen appears as it does in Figure 15.
Figure 15: Kiosk mode
To remove the previous software on a handheld in Kiosk mode, follow these steps.
OTE:N You can also remove Kiosk software by using the procedure "Removing Software Using Factory Reset/Clean Boot
(Recommended)" on page 7. However, if there is software on the handheld other than the Badger Meter software
application that you do not want to remove, use this procedure.
1. Tap the screen title bar to the right of the Badger Meter
software name.
Result: The Unlock button appears as shown in Figure 16.
OTE:N The screen title bar may be different, depending
on the software version you are removing, but
should have “Badger Meter,“ “BMI“ or “Badger “ in
the name.
2. Tap the Unlock button.
Figure 16: Tap Unlock button
Removing Previous Software Versions
Page 11 May 2015 ORI-PM-00100-EN-03
To Next Page
Loading...