91
EXTERIOR FEATURES
EXTERIOR FEATURES
GRP
GRP components need to be washed, waxed
and cared for like a car. Chemicals and dirt can
collect during storage, and the outer surface
called a gel coat can be stained or marked
when chemicals combine with rain or dew.
Most stains or marks can be removed with mild
dish-washing detergent, but more stubborn
marks may require a rubbing compound. To
help keep your GRP components looking
almost like new, it is wise to wash the parts
monthly (or more frequently) using mild dish-
washing detergent, but avoid using strong
alkaline (e.g. tri-sodium phosphate) or acidic
cleaners or abrasives. Waxing the components
once or twice a year with a good grade paste
wax will help to maintain the colour and finish.
ROOFLIGHTS
HEKI ROOFLIGHTS:
OPENING IN THE TILT SETTING
1. Press the locking buttons at both catches
on the glass and turn inwards through
approx. 90°.
2. Grasp the bar in the middle, unclasp from
the anchoring fasteners, swivel the bar
down and push the glass dome upwards.
(Glass dome is assisted after approx.
150mm by the two pneumatic springs.)
3. Swivel the bar towards the glass dome
and clip into position.
4. To close the HEKI, perform steps (1–3) in
reverse order.
OPENING IN THE INTERMEDIATE SETTING
1. Open both catches on the glass.
2. Grasp the bar in the middle, unclasp from
the anchoring fasteners, swivel down
and push the glass dome upwards. (Glass
dome opens automatically after approx.
150mm through the two pneumatic
springs.)
3. Open both fasteners, and swivel the bar
towards the intermediate setting and pull
the glass dome down until the bar rests in
the hold.
4. Secure the bar with the two fasteners.
5. To close HEKI, perform steps (1–4) in
reverse order.
OPENING IN PERMANENT VENTILATION SETTING
1. Open both catches on the glass.
2. Push glass dome up approx. 2cm with
both hands on the two catches and turn
the catches to fix them in the ventilation
setting.
3. To close HEKI, perform steps (a–b) in
reverse order.
CLOSING THE BLIND
1. To close the blind, grasp the end rod
(without grip) in the recess and engage in
the opposite end rod (with grip).
2. You can move both joined end rods to
adjust the blind to the required position
(black out/fly screen/sun shade).
To Next Page
Loading...
