Baja motorsports WR200 User Manual

Follow all instructions when assembling this mini bike. If any parts are damaged or missing, those parts must be replaced
before proceeding.
WARNING: To reduce the risk of injury, you must read and understand this assembly guide before attempting to
assemble this product.
ASSEMBLY GUIDE
GUÍA DE ARMADO
WR200 / HEAT / WARRIOR /
CARBON / MINI BAJA
MB200
SAVE THIS GUIDE FOR FUTURE REFERENCE
Siga todas las instrucciones al armar este mini motocicleta. Si falta alguna pieza o hay piezas dañadas, dichas piezas deben
reemplazarse antes de proceder a utilizar el producto.
ADVERTENCIA: Para reducir el riesgo de lesiones, debe leer y comprender esta guía de armado antes de
intentar armar este producto.
GUARDE ESTE MANUAL PARA FUTURAS CONSULTAS

Baja motorsports WR200 Specifications

General

Front Brakes	Disc
Rear Brakes	Disc
Tires Front	2.75-21
Tires Rear	4.10-18
Fuel System	Carburetor
Ignition	CDI
Final Drive	Chain
Starting System	Electric / Kick
Transmission	Manual
Front Suspension	Telescopic fork
Height	45.3 inches
Wheelbase	54.3 in
Engine Type	Single cylinder

Summary

Assembly Guide Introduction

Safety Warning for Assembly

Read and understand this assembly guide before attempting to assemble the product to reduce the risk of injury.

Rules for Safe Assembly

Adherence to Torque Specifications

Strictly adhere to all torque wrench tightening specifications to prevent serious personal injury.

User Training and Experience Requirement

Unpacking Procedures

Safe Unpacking Steps

Handling the Shipping Crate

Post-Unpacking Inspection

Loose Parts List and Warnings

Parts Identification

Lists and identifies all loose parts required for assembly with their quantities.

Parts Condition Warning

Do not assemble if parts are damaged or missing; use original manufacturer parts.

Assembly Steps

Assembly Safety Precautions

General warnings about torque, modifications, and disconnecting spark plug wire during assembly.

Installing the Handlebar

More Assembly Steps

Verifying Tire Pressure

Check and inflate tire pressure to the recommended 12 psi when tires are cold.

Engine Lubricant Procedures

Checking and Changing Engine Lubricant

Final Preparation Steps

Verifying Fluid Levels

Adding Gasoline