21
VEHICLE WASHING
Cleaning the vehicle regularly can slow down color fading and make it easier to
check for damage and/or oil leakage.
1.
After pre-wiping, the vehicle should be washed with clean water to remove
dirty residues so as to prevent corrosion. Plastic subassemblies should be
cleaned by wiping with a cloth or foam soaked in neutral detergent solution,
followed by rinsing with clean water.
2.
After vehicle has air dried, lube drive chain then run engine at idle speed for a
few minutes.
3.
Prior to driving, carefully check brake system, repair or adjust if necessary.
CAUTION
Washing the Mini Bike with over-pressurized water may cause damage to
some of its components. Therefore, do not use a pressure washer to clean
the vehicle. The following parts should be cleaned using low pressure
water:
— Wheel hub
— Exhaust pipe
— Fuel tank and lower portion of cushion
— Carburetor
— Head lock and ignition switch
To Next Page
Loading...