Bajaj pulsar DTS-i - Page 125

SOP FOR DISMANTLING ENGINE
Pulsar 150/180 DTS-i
Service Station Manual
121
Dealer Development Center
Akurdi Pune
Air Filter
Crankcase Clutch Side :
Using Sp. Tool : Bearing Driver set-37
1030 61
Remove :
• Bearing for input shaft assembly
from crankcase RH
(A)
Using Sp. Tool : Bearing Extractor 37
1030 68
Remove :
• Needle roller bearing for output
shaft assembly from crankcase RH
(B)
Crankcase Clutch Side :
Using Sp. Tool : Bearing Extractor 37
1030 72
Remove :
• Bearing for drum change(C)
A
B
A
Using Sp. Tool : Bearing Extractor - 37
10DJ 77
Remove :
• Bearing for body balancer gear
bearing from crankcase LH
(A)
Crankcase Magneto Side :
Remove :
Using Sp. Tool : Bearing Extractor 37
1030 72
Remove :
• Oil Seal
• Bearing for output shaft assembly
from crankcase LH
(A)
A