Bajaj pulsar DTS-i - Page 126

DISMANTLING ENGINE SUB ASSEMBLIES
Note : Similarly remove the other Rocker shaft &
Rocker Arm from head over.
Using Sp. Tool : Bearing Extractor - 37
10DJ 76
Remove :
• Bearing for input shaft assembly
from crankcase LH
(A)
A
Remove :
Using Sp. Tool : Bearing Driver set
371030 74
Remove :
• Bolt
• Bearing stopper
• Bearing for gear change drum from
crankcase
(A)
Magneto Cover :
Remove :
• 2 phillips head screws (A) of Pulsar
coil (E) mounting.
• Bolts (B) of stator assembly.
• 1 phillips head screws (C) of stopper
• Stator coil assembly (D) along with
Pulsar coil.
A
E
D
C
B
Cylinder Head Cover :
Using Sp. Tool : Rocker pin remover - 37
10DH35
Remove :
• Rocker shaft
• Rocker arm
• Set of washers (1 wave & 2 plain)
(A)
(C)
(B)
A
B
C
A
Pulsar 150/180 DTS-i
Service Station Manual
122
Dealer Development Center
Akurdi Pune