CUSTOMER INFORMATION
Pulsar 150/180 DTS-i
Service Station Manual
16
Dealer Development Center
Akurdi Pune
Safe Riding Tips
Daily Safety Checks
Before riding the motorcycle be sure to check the following items. If any irregularities are found during these checks, refer
to the Maintenance chapter and see your dealer for the action required to return the motorcycle to a safe operating
condition.
What to check Check for
Fuel Enough fuel for the planned distance of operation, no leaks in the fuel lines.
Engine Oil Oil level between upper and lower marks.
Throttle 1. Correct free play in the throttle cable (2 to 3 mm)
2. Smooth operation and positive return of the throttle grip to the closed position.
Steering Lock Correct operation.
WARNING
Failure to perform these checks every day before
you ride may result in serious damage or severe
accident.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Always wear ISI helmets while driving or riding. Your helmets should conform to appropriate
Indian standards.
Read thoroughly the instructions in this manual and follow them carefully.
Avoid unnecessary accessories for the safety of both rider and other motorists.
Get familiar and follow traffic rules and regulations in your states as well as general traffic
signs.
Do not overload your vehicle.
Familiarise yourself well with starting, acceleration and braking of the vehicle.
When applying the brakes, use both, the front and rear brakes. Applying only one brake may cause the vehicle to
loose control.
During monsoon drive the vehicle more cautiously. Remember vehicles skid more easily during light showers.
Always carry vehicle registration papers, insurance and a valid driving licence with you.
MONSOON CARE : Fit & Finish Parts
The appropriate surface preventive coat to be applied to avoid rusting on account of adverse atmospheric conditions.
Clean & lubricate all the important parts as detailed in a periodic maintenance chart.
Do not obstruct engine cooling by adding mud protection sheet from front.
Vehicle cleaning to be done with soft & clean wet cloth to avoid scratches on painted parts.
Do not apply direct water jet on painted, electrical / electronic parts.
To Next Page
Loading...
Need help?
General
