CUSTOMER INFORMATION
Pulsar 150/180 DTS-i
Service Station Manual
17
Dealer Development Center
Akurdi Pune
What to check Check for
Brakes 1. Correct rear brake pedal play (25~30 mm) Applicable to 150 cc.
2. Brake lining wear indicator within ‘USABLE RANGE’.
3. No dragging.
Drive chain 1. Proper slack (25~35 mm).
2. Adequate lubrication.
Lighting Operation of all lights.
Horn Correct functions.
Steering 1. Smoothness.
2. No restriction of movement.
3. Loose or Tight.
Clutch 1. Correct lever play. (2 to 3 mm).
2. Smooth operation of lever.
Side and Center Stand Return to their fully up position.
Tyres 1. Correct pressure.
2. Adequate tread depth.
3. No cracks or cuts.
Mirrors Correct position.
Running In
Proper running-in is important for the better life and trouble free performance of the vehicle.
During first 2000 kms running-in period do not exceed following speed limits.•
Kms 1st 2nd 3rd 4th 5th
0 - 1000 14 22 30 37 44
1000 - 2000 18 28 38 46 55
Always keep the speed below the limits mentioned in the table.
Do not race the engine excessively.
Do not start moving or race the engine immediately after starting. Run the engine for a minute at idle speed to give
the oil a chance to work up into the engine.
FUEL SAVING TIPS
A well maintained vehicle and good driving can contribute a lot to the saving of petrol. Following are a few simple fuel
saving tips.
Ride smoothly and steadily at an optimum driving speed of 40 to 45 km/hr or within the economy band position.
Avoid harsh braking.
Change the gear judiciously according to the speed requirement.
Don’t overload the vehicle above the specified payload.
Use the accelerator judiciously.
Cut off the engine if you want to stop for more than two minutes.
•
•
•
•
•
•
•
•
•
To Next Page
Loading...
Need help?
General
