Relay :
Solenoid Relay (Inspection Using Multi meter)
Coil Resistance Meter +ve
Meter -ve
Reading
X 200 Ohm
3.8 2.0 Ohm+
Black
Red/Yellow
Caution : When replacing a fuse be sure the new fuse matches the specified fuse rating for
that circuit. Installing of a fuse with a higher rating may cause damage to wiring and
components.
Fuse :
Main Fuse Inspection (Capacity = 15 Amp) / Secondary Fuse
Inspection (Capacity = 10 Amp)
•
•
•
Inspect the fuse element
If it is blown out, replace the fuse.
If a fuse fails during operation, the electrical system to
determine the cause, and then replace it with a new fuse of
proper amperage.
Clutch Switch :
The clutch switch has 3 wires and it has contact configuration of
this vehicle is not having interlock relay Instead its working is taken
care of by clutch switches.
ELECTRICAL CHECKING
PROCEDURES
Pulsar 150/180 DTS-i
Service Station Manual
220
Dealer Development Center
Akurdi Pune
OFF - Clutch
lever not pressed
ON - Clutch
lever pressed
Meter Range
Light Green Yellow / Green Black /Yellow
l
l
ll
ll
To Next Page
Loading...
