Balboa bwa BP2000 - User Manual

Quick Install Guide For bwa™ Kit - BP2000/2100
– Use a phillips screwdriver to remove
the 2 top screws that hold the system
cover in place.
TOOL YOU WILL NEED
– Phillips screwdriver
STEP 1
STEP 2
1
2
– Insert the Balboa Wi-Fi Cable into either Panel Jack
J34 or J35.
ZOOM IN
STEP 3
– Remove 2 screws to open the cable holder.
WARNING!
Please contact an electrician or your local electrical company to
connect the Wi-Fi connector for you. DO NOT OPEN THE SPA
SYSTEM AND ATTEMP TO CONNECT THE WI-FI CONNECTOR
YOURSELF. The high electrical voltage will harm or kill you.

Summary

Tools and Warnings

Tools Required

A Phillips screwdriver is needed for the installation process.

Electrical Safety Warning

Contact a professional for Wi-Fi connector installation due to high voltage risks.

Installation Steps

Step 1: Remove System Cover

Use a Phillips screwdriver to remove the 2 top screws holding the system cover.

Step 2: Connect Wi-Fi Cable

Insert the Balboa Wi-Fi Cable into either Panel Jack J34 or J35.

Step 3: Open Cable Holder

Remove 2 screws to open the cable holder before proceeding.

Step 4: Secure Cables

Place the Wi-Fi cable and Control Panel cable inside the wire holder.

Step 5: Finalize Installation

Insert the plastic holder and 2 screws, then close and secure the system cover.

Final System Appearance

Completed Installation View

Illustration showing how the system should look after installation.

Wi-Fi Module Placement Note

Position the Wi-Fi module away from any metal tub supports.

Balboa bwa BP2000 Specifications

General

Brand	Balboa
Model	bwa BP2000
Category	Hot Tub
Language	English