Need help?Do you have a question about the BALCO HE180021 and is the answer not in the manual?
General| Build Volume | 180 x 180 x 180 mm |
|---|---|
| Layer Resolution | 0.05-0.3 mm |
| Nozzle Diameter | 0.4 mm |
| Connectivity | USB, SD Card |
| Supported Materials | PLA, ABS, PETG |
Covers high temperatures, moving parts, and operational safety.
Discusses ventilation, water exposure, temperature, and power.
Lists major parts of the Balco 3D Printer Touch.
Details accessories supplied with the printer.
Details print technology, build volume, resolution, and speed.
Covers operating temperatures, software, electrical input, and physical dimensions.
Explains the basic concept of 3D printing and FFF technology.
Outlines the process from 3D design to a printed object.
Emphasizes setup, printing process, and factors affecting print time.
Key checks for GCODE, cables, bed level, and nozzle.
Guidance on monitoring, unattended operation, and object removal.
Identifies and labels major parts visible from the front.
Identifies and labels major parts visible from the rear.
Details the parts related to the print bed assembly.
Shows Touch Screen, SD Port, Power Socket, and Switch locations.
Explains file selection, print controls, settings, and navigation.
Covers preheating, resetting position, manual axis movement, and extrusion.
Explains adding and removing filament.
Guides users through automated and manual bed levelling.
Details PID settings, motor configuration, and factory reset.
Instructions for unpacking, placing parts, and initial cable connections.
Completes connections, assembles spool holder, and powers on the printer.
Pre-levelling checks and using the on-screen wizard for bed levelling.
Step-by-step guide for manual bed levelling and fine-tuning gap.
Discusses filament types, properties, and recommended usage.
Step-by-step guide to load, remove filament, and storage.
Steps for transferring GCODE files and starting prints from the SD card.
Steps for safely removing prints, including scraper techniques.
Explains GCODE, slicer software, and adding the printer profile to Cura.
Instructions for replacing the print mat and cleaning a blocked nozzle.
Steps to unclog extruder and routine checks for printer components.
Advice on storing the printer in a cool, dry, dust-free environment.
Lists tools and equipment needed for post-processing prints.
Methods for removing support structures using tools like pliers.
Steps for sanding models to smooth layer lines and improve finish.
Guide to applying primer, paint, and varnish for a professional look.
Regular checks for belts, cables, fans, and chassis integrity.
Instructions for disposing of packaging and the printer responsibly.
Addresses clicking sounds, file errors, extrusion, adhesion, and warping.
Solutions for print interruptions, motor failures, and stringing.
Troubleshooting printer not turning on and connectivity issues.
Guidance on filament purchase, brands, and type compatibility.
Definitions for common terms like ABS Filament, Brim/Raft, Display, Firmware.
Definitions for GCODE, Slicing, Heated Bed, Nozzle, SD Card, Spool, Stepper Motor.
Lists references for 3D models used in the manual with links.
To Next Page
