BALDOR AIR COMPRESSOR
Attention
The compressor will automatically stop when it is in no-load working time longer than the setting time,
no inspecting or maintaining at this time because the compressor will resume at any time. Start & stop of
the fan is automatic controlled if the machine is with single fan, so doesn’t touch the fan avoid cause
personal injuries. Cut off the power before checking the machine.
The compressor will suddenly stop if no power. Remember to cut off the power in order to avoid
burning electronic parts when there is sudden power supply.
Chapter Seven: Daily Maintenance
Screw air compressor maintenance period and content
Check the oil level before start and during the working, the display
situation of panel, the setting pressure. Check the temperature, noise
when Oil barrels drainage etc.
check the leakage and clean the machine
Check the vacuum index of the air filter and clean it. Replace the oil
filter and change the oil if new machine.
Manually check safety valve, thermostat and clean the cooler, electric
system remove dust.
Replace air filter, oil filter, and oil. Check the tightness of the belt and
make corresponding adjustment. If beyond the adjustment scope,
change it in time. Check the moving parts fastening bolt. Clean the
cooler.
To Next Page
Loading...
Need help?
General