Banana Pi BPI-M2+ - H3 Manual Build Howto

H3Manualbuildhowto
bananapiBPI-M2+useallwinnerH3chiponboard.
ThispagedescribestheprocesstocombineAllwinnersbinaryboot0,anSDKU-Boot,anSDKlinuxkernelandotherbits
togethertocreateausefulSD-cardfromscratch,thebasisforfurtherhacking.
ThispageisonlysuitedforH3baseddevices,pleaselookunderSeealsoforothermanualbuildhowtos.
Weofcoursedonotbuildawholedistribution,weonlybuildU-Boot,thekernelandahandfuloftools,andthenusean
existingrootfstogetausefulsystem.Dependingontherootfssize,youmightwanttousea2GBorlargerSDCard.SD-
cardpartitioningandformattingwillbetakencareoflater.
Link:
http://linux-sunxi.org/H3_Manual_build_howto
H3Manualbuildhowto
109