Banana Pi BPI-M2+ - Bpi-Bootsel Command

bpi-bootselcommand
Howtousebpi-bootselcommand(Multi-useSDcardsupported)
Fromnowon,justdownloadeitherM2orM3,thenyoucanswitchtoanyofthemasyouwish!
bpi-bootselv1.0.5
usage:bpi-bootsel
bpi-bootselIMGFILE
bpi-bootselIMGFILEDEVICE
1. DownloadBPI-Tools,pleaserunthefollowingcommand
wgethttps://github.com/BPI-SINOVOIP/BPI-files/raw/master/debs/bananapi-bpi-tools_1.0.3_armhf.deb
1. Setupdevelopmentenvironment
2-1:OnX86-PC(Ubunut12.04)
sudoecho"foreign-architecturearmhf">>/etc/dpkg/dpkg.cfg.d/multiarch
2-2:OnX86-PC(Ubunut14.04)
sudodpkg--add-architecturearmhf
2-3:OnBananaPIM3/M2Plusdonothing
2. InstallBPI-Tools
sudodpkg-ibananapi-bpi-tools*.deb
bpi-bootselcommand
88