B&B Electronics Elinx EIR510-2MC-T - Page 36

28
Manual Documentation Number: EIR510-xSFP-T_0708m
B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104 – www.bb-elec.com
B&B Electronics – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445 – www.bb-europe.com
no accounting I
Clear interface
accounting information
switch(config)#interface
fastEthernet 2
switch(config-if)#no accounting
Trunk Commands Set
Commands Level Description Example
aggregator priority
[1~65535]
G
Set port group system
priority
switch(config)#aggregator priority
22
aggregator activityport
[Group ID]
[Port Numbers]
G
Set activity port switch(config)#aggregator
activityport 2
aggregator group
[GroupID] [Port-list]
lacp
workp
[Workport]
G Assign a trunk group
with LACP active.
[GroupID] :1~3
[Port-list]:Member port
list, This parameter
could be a port
range(ex.1-4) or a port
list separate by a
comma(ex.2, 3, 6)
[Workport]: The
amount of work ports,
this value could not be
less than zero or be
large than the amount
of member ports.
switch(config)#aggregator group
1 1-4 lacp workp 2
or
switch(config)#aggregator group
2 1,4,3 lacp workp 3
aggregator group
[GroupID] [Port-list]
nolacp
G
Assign a static trunk
group.
[GroupID] :1~3
[Port-list]:Member port
list, This parameter
could be a port
range(ex.1-4) or a port
list separate by a
switch(config)#aggregator group
1 2-4 nolacp
or
switch(config)#aggregator group
1 3,1,2 nolacp