B&B Electronics Elinx EIR510-2MC-T - Spanning Tree Commands Set

Manual Documentation Number: EIR510-xSFP-T_0708m 31
B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104 – www.bb-elec.com
B&B Electronics – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445 – www.bb-europe.com
hybrid-link untag
[UntaggedVID]
tag
[TaggedVID List]
VLAN by trunk group
hybrid-link untag 4 tag 3,6,8
or
switch(vlan)#vlan 8021q trunk 3
hybrid-link untag 5 tag 6-8
show vlan [GroupID]
or
show vlan
V
Show VLAN
information
switch(vlan)#show vlan 23
no vlan group
[GroupID]
V
Delete port base group
ID
switch(vlan)#no vlan group 2
Spanning Tree Commands Set
Commands Level Description Example
spanning-tree enable G
Enable spanning tree switch(config)#spanning-tree
enable
spanning-tree priority
[0~61440]
G
Configure spanning
tree priority parameter
switch(config)#spanning-tree
priority 32767
spanning-tree max-age
[seconds]
G
Use the spanning-tree
max-age global
configuration
command to change
the interval between
messages the
spanning tree receives
from the root switch. If
a switch does not
receive a bridge
protocol data unit
(BPDU) message from
the root switch within
this interval, it
recomputed the
Spanning Tree
Protocol (STP)
topology.
switch(config)#spanning-tree
max-age 15